Sunstar 18K BTU Infrared Heater NG Tstat Floor Stand - RECONDITIONED FULL WARRANTY
Installing a vent free gas heater is a safe and cost efficient way to heat a single room. The SC18T1NG uses Natural Gas (NG). It can be installed in a wall or an optional floor stand is available. It is a thermostat controlled heater with a Piezo ignition and standing pilot. The top mounted controls are easily accessible. Simply turn it on and the heat will begin warming your room immediately. Thermostatic heat control from low to high.
The 18,000 BTU heater includes ODS and flame failure safety features. No electricity is required to run this unit. It is a great heater to have in the event of a power failure because it will keep on heating! It is reliable and virtually 100% efficient - all the heat generated is emitted into your home.
The SunStar SC18T1NG is a slim, compact heater. It measures 25"H x 19.75"W x 9.5"D. Vent-free installation does not require an outside wall giving you more possibilities for installation. It can be as low on a wall as 2" from the floor or as high as 36" from the ceiling. Clearance on the sides is 13".
Installation in Mobile Homes as permitted by state and local codes.
Vent-Free Products Cannot Be Shipped To The State Of California.
SunStar Warranty Information
General Features
- Installation Type:Floor or Wall Mount
- Fuel Type:Liquid Propane (LP)
- Installation Kit:Wall Mount Included, Floor Stand Kit Optional
- Type of Venting:Vent Free
- Tilt Switch:NA
System Data
- Heating BTUs:18000
- CFMs:NA
- Blower:Optional
- Flame Type:Infrared / Radiant
- Ignition Type:Standing Pilot
- Control Type:Thermostatic
Gas Requirements
- Gas Connection Size (in.):1/2"
- Manifold Pressure (in.):10" w.c.
- Inlet Gas Pressure (Min.):11" w.c.
- Inlet Gas Pressure (Max.):14" w.c.
Clearances
- Top to Ceiling (in.):36"
- Bottom to Floor (in.):2"
- To Side Wall (in.):13"
SunStar Warranty Information